[GMCnet] timing motor [message #68880] |
Wed, 30 December 2009 09:44 |
gmc gmc
Messages: 69 Registered: May 2009
Karma:
|
Member |
|
|
Hi all. I reply to Jim and others when we get time. but thanks Jim and all.
Friend here near Houston and I might try to time motor later. On start it
takes a hard crank or 2 or 3 to get it fired. Alternator guy other day told
me that is hard on battery and starter. I tried to search some GMC sites and
even maillist but was unable to find tips and tricks to doing timing. Is
there a link to tips on this matter? if not he asked where is piston #1
located? and what is +- degrees I guess? what else we need to know? how is
easiest way to do this?
thanks all appreciate it.
Mike and Steph
ps. Brake light came on, added fluid to chamber in front, light off, after
some city driving light on, added 3/8 inch or so. after a bit driving light
on again. I will check this am and see. hummmm
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|