temp sender [message #59620] |
Sat, 10 October 2009 13:05 |
gmchunter
Messages: 222 Registered: March 2008 Location: ORANGE, CA
Karma:
|
Senior Member |
|
|
Read about the TS6469 temp sender on list and at BDub's site and decided to install. Bought TS6469 at NAPA and installed.
The old temp sender was stamped TS6 on flats where socket grabs it. The new temp sender had no stamping there but was was stamped 415 on flat bottom of temp sender that sticks into water passage.
Anyway the new temp sender seemed to respond a bit quicker and very quickly went up to the halfway mark at idle.
Two things:
1. according to tables published earlier that would seem to be 215 degrees which seems a bit high for just sitting there idling. Note I have new motor with about 1500 miles, recored radiator, etc., does that seem normal?
2. The fan seemed to be spinning but I am not hearing any "roar" that people talk about. Is that normal?
Michael
|
|
|