GMCforum: GMCnet » Huber torsion bar

Home » Public Forums » GMCnet » Huber torsion bar

Show: Today's Messages :: Polls :: Message Navigator

Huber torsion bar [message #371423]

Sat, 01 July 2023 20:49

Bill Van Vlack

Messages: 419
Registered: September 2015
Location: Guemes Island, Washington

Karma:

Senior Member

I recently purchased a pair of torsion bars that the seller stated were the heavier Huber ones. They measure 1.26 in diameter, have a 'Sway-A-Way' sticker and are painted (probably powder-coated) RED. I measured my OEM ones and they ar 1.21" diameter. From some research on this forum, I learned that the first run of Huber bars were WHITE. One end of these bars have a longer hex than the other; 1-3/4" vs 1-1/8" (Approximately - the ends have a rubber cover that I didn't remove.

I suspect these are the second batch that Bill Huber had made. Can anyone confirm that the second batch was RED?

Thanks!

Bill Van Vlack

Bill Van Vlack '76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath, Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o mid November 2015.

Report message to a moderator

[Message index]

		Huber torsion bar By: Bill Van Vlack on Sat, 01 July 2023 20:49
		Re: Huber torsion bar By: JohnS on Sun, 02 July 2023 13:42

Previous Topic:	The GMC Motorhome Registry
Next Topic:	Deleting a single pic from a photo site album

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Nov 15 16:56:38 CST 2024

Total time taken to generate the page: 0.00914 seconds