[GMCnet] RH Output Shaft Bearing [message #367246] |
Mon, 18 October 2021 12:26 |
Bikertrash
Messages: 16 Registered: August 2021 Location: Northern Indiana
Karma:
|
Junior Member |
|
|
Hey everybody, I put my 3.70 final drive in the coach and why I have the RH
output shaft out I figured I should replace the bearing. the old bearing
does not feel crunchy but does have some slop left right up and down in the
support bracket.I looked up the part number "RW507-CR" and ordered a Timken
RW507CR. I have not pressed the old bearing off the shaft yet but my
assumption is it is just a pressed fit near the bearing location and should
slide partially down the shaft correct? If so then I have the
wrong bearing.
As always, thanks for your help!
--
Scott Campbell
Jack of All, Master of None!
President AMCA River Valley Chapter
1980 FXEF, 1997 XL, 2000 FLHT, 2014 FLD
1982 Chevy G20
1973 GMC Glacier Motorhome
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Scott & Mindy Campbell
Northern Indiana
1973 26' Glacier, 88,000 miles, 16" Alcoa Wheels, Rust free frame (painted), Stock air suspension, New fuel lines & sending units, New brake lines, Stock front end, Onan generator Newer Coleman A/C
|
|
|