Air Supply Line [message #364668] |
Sun, 13 June 2021 16:40 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma:
|
Senior Member |
|
|
Hello all,
I have a 1977 Birchaven with both a York compressor and tank up front on the left side. I am currently converting to the Micro-Level System.
Is it a good idea to increase the 1/4" line size from the tank in the front to the manifold in the rear?
The short line from the front compressor to the front tank is 1/4" copper. I was just thinking if there is any real benefit to inflating the suspension quickly or even if the increased line size will have a noticeable effect.
As always your thoughts are appreciated.
Take care all,
Tom K.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|