[GMCnet] Onan board connections [message #357063] |
Tue, 21 July 2020 15:12 |
stu@97381.com, Emery
Messages: 232 Registered: June 2020
Karma:
|
Senior Member |
|
|
I was working in my Onan and removed the wires from the board. I wasn’t too concerned because the small numbers inside the Molex connector would guide me.
The wires are marked with numbers for the terminals but my wires had darkened and discolored so I couldn’t read most of them. But inside the plug are very small numbers that correspond to the terminals.
I hooked the wires back up but I had a long one left that went to the number 4 terminal. There was a number four terminal at the top of the board that was bent over so it would not be used. This was a long wire so I knew that it went to the bottom of the board. I was left with one unused terminal between number nine and number eleven. But it was labeled with a 1 besides it. Where did the number four wire go?
I finally called Jim Miller and he checked a board in his shop and verified that the wire number 4 was plugged into the terminal Marked with a 1.
So if anyone has to figure out the connections by the little numbers inside the Molex plug they are all correct EXCEPT wire 4.
Emery Stora
77 Kingsley
Frederick CO
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|