Re: [GMCnet] electrical connection [message #354751] |
Sat, 16 May 2020 16:58 |
Emery Stora
Messages: 959 Registered: January 2011
Karma:
|
Senior Member |
|
|
You should be able to squeeze the connector to make a tighter fit. Don’t use regular pliers or you’ll probably make it too tight.
I use small vice grips and possibly do a trial fit and if it’s not tight enough tighten them a little and try again.
Also put some dielectric grease for better contact.
Emery Stora
77 Kingsley
Frederick, CO
> On May 16, 2020, at 3:32 PM, Hanson Email via Gmclist wrote:
>
> I have (several) electrical connection(s) that is/are intermittent because
> of dirt/corrosion/gunk etc but I can not clean properly as it is a female.
> Anyone with suggestions on how to make a connection like that make a
> 'better' connection? Electrical spray cleaner? The proper type of 'grease'?
> I would rather not cut out the connection involved with a rewire around
> solution. I would rather "make my life easier through chemistry". I think
> Dupont said that way back when.
>
> Dean Hanson 75 Avion
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|