Engine water pump install questions [message #353721] |
Sat, 11 April 2020 19:38 |
Scott Nutter
Messages: 782 Registered: January 2015 Location: Houston/San Diego
Karma:
|
Senior Member |
|
|
I'm getting ready to install a new water pump, and I'm looking for some advise.
1... the book states to coat the bolts in motor oil. Would there be anything better to use? Maybe anti seize, synthetic grease, synthetic oil?
2... is the bypass hose from the water pump to the thermostat housing just standard heater hose?
3... the book states to use liquid gasket sealer to adhere the gasket to the water pump. I usually use aviation gasket Sealer. Is that too extreme? Or should I use something different?
4... should I use gasket sealer on both sides of the water pump gasket? I would think not..
Or am I being too anal..Thanks for the help, Scott.
Scott Nutter
1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI
Houston, Texas
[Updated on: Sat, 11 April 2020 21:44] Report message to a moderator
|
|
|