GMCforum: GMCnet » Supporting Engine From The Bottom

Home » Public Forums » GMCnet » Supporting Engine From The Bottom (engine supports)

Show: Today's Messages :: Polls :: Message Navigator

Supporting Engine From The Bottom [message #351553]

Thu, 23 January 2020 19:02

Melbo

Messages: 144
Registered: August 2018
Location: Albuquerque NM

Karma:

Senior Member

I remember seeing a picture of a device that someone made to hold the engine up. I was a horse shoe shaped wood setup that they used to jack up the engine from the bottom.

I was trying to find my bookmark but I can't find it and I was going to do something similar to raise the engine an inch or two.

The comment was that you do NOT want to dent the oil pan so this pushed up on the edge of the pan against the block.

Any help or information would be greatly appreciated.

Thanks in advance

Melbo

Albuquerque NM Bus Conversion 1978 MCI 1973 GMC

Report message to a moderator

[Message index]

		Supporting Engine From The Bottom By: Melbo on Thu, 23 January 2020 19:02
		Re: Supporting Engine From The Bottom By: GMC Cruse on Thu, 23 January 2020 21:31
		Re: Supporting Engine From The Bottom By: Melbo on Fri, 24 January 2020 10:16
		Re: [GMCnet] Supporting Engine From The Bottom By: powwerjon on Fri, 24 January 2020 10:37
		Re: [GMCnet] Supporting Engine From The Bottom By: powwerjon on Thu, 23 January 2020 20:15

Previous Topic:	Cold Weather Dry Camping
Next Topic:	[GMCnet] Engine Vents

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Sep 18 18:27:23 CDT 2024

Total time taken to generate the page: 0.00792 seconds