[GMCnet] rollers and rockers. [message #350277] |
Fri, 22 November 2019 16:41 |
Dean Hanson
Messages: 114 Registered: May 2018
Karma:
|
Senior Member |
|
|
I used my short block on a overhauled engine where the cam went flat and
installed Mondello stuff on up, including intake and stainless rollers and
rockers. Also kept my quadjet. After many thousands of miles, As far as I
know, the current owner is a happy camper. I had to machine the heads to
keep the pushrods from bending, but that was a Mondello defect. From a dead
start , if you wanted to get on it a little, you would have to let up to
stop the spin. Turned a lot of heads at stoplights.
You don't need that kind of muscle for these motorhomes. I would not spend
that money again on that muscle.or Mondello.
Dean C. Hanson 75 Avion 76 Eleganza11
P.O.Box 2096
Fremont, Ca. 94536
(510) 657-9600
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|