GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Thermasan (injector)
Thermasan [message #349411] Fri, 18 October 2019 12:45 Go to previous message
Rich Kinas is currently offline  Rich Kinas   United States
Messages: 113
Registered: July 2019
Karma:
Senior Member
Matt and anybody that has any knowledge....

I am replacing my exhaust manifold gaskets, exhaust down pipes ,pipe flange gaskets, mufflers, etc all because of that broken lower dip-stick tube. Actually it just started the process that I would have eventually gotten around to eventually. So while I am installing the new exhaust down pipes, I figured I would weld bungs into place for my future ThermaSan installation. I am actually creating a modified ThermaSan install since the only parts I actually have on hand are the pump and motor. For my injector I am going to try to use a "M18x1.5 O2 Sensor CEL Eliminator" that threads into a standard M18x1.5 O2 bung that I am going to weld onto the down pipe about 12 inches from the manifold connector flange. And about 6 inches from the manifold connector flange I am planning on mounting a 1/8" NPT steel bung that I will install a "2M EGT K type thermocouple exhaust probe High Temp Sensor" to monitor my exhaust temperature. So my question so far is does this plan sound reasonable? Is if sufficient to mount the ThermaSan injector just 6 inches down stream of the thermocouple, or should I mount it further down closer to the mufflers? I figure that what ever I end up using for my injector the O2 sensor bung should be able to accommodate it.

Rich


Rich Kinas 1976 Elaganza II Orlando, FL
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: a/c Request Wire on a Howell Wire Harness
Next Topic: External house battery chargers
Goto Forum:
  


Current Time: Thu Sep 19 21:57:11 CDT 2024

Total time taken to generate the page: 0.00936 seconds