GMCforum: GMCnet » Axle Nut Torque

Home » Public Forums » GMCnet » Axle Nut Torque

Show: Today's Messages :: Polls :: Message Navigator

Axle Nut Torque [message #348015]

Tue, 17 September 2019 10:57

MikeB

Messages: 133
Registered: December 2018
Location: South Bama

Karma:

Senior Member

Hey folks,
I just bought my coach and having ball joints replaced. Im gathering torque info for the technician working on the repair. I just wanted to make sure this is still an accurate statement for the axle nut.

"Install drive axle washer and nut. Torque nut to 140 ft. lbs. If necessary to align cotter pin slot, tighten nut and install NEW cotter pin and crimp. Torque not to exceed 280 ft. lbs. NOTE: Do not back off nut to install cotter pin.Mark A"

Upper Ball Joints 40-60
Lower 100-125

M Beam 75’ Avion TBI EBL , 3.70 LSD and other stuff Zuki Sidekick, Dozier Al

[Updated on: Tue, 17 September 2019 10:59]

Report message to a moderator

[Message index]

		Axle Nut Torque By: MikeB on Tue, 17 September 2019 10:57
		Re: Axle Nut Torque By: tmsnyder on Tue, 17 September 2019 12:11
		Re: [GMCnet] Axle Nut Torque By: Richard Denney on Tue, 17 September 2019 12:38
		Re: Axle Nut Torque By: Matt Colie on Tue, 17 September 2019 12:57
		Re: Axle Nut Torque By: MikeB on Tue, 17 September 2019 19:15
		Re: Axle Nut Torque By: MikeB on Tue, 17 September 2019 19:36

Previous Topic:	2018-19 Honda Odyssey seats
Next Topic:	[GMCnet] Trying to charge discharged house batteries.

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Nov 06 06:27:52 CST 2024

Total time taken to generate the page: 0.01165 seconds