| Clips for wire management windshield main support. [message #346099] |
Mon, 05 August 2019 18:38  |
 |
dservati1
Messages: 109
Registered: December 2013
Location: Western New York -Rochest...
Karma:
|
Senior Member |
|
|
hi all I'm looking for a clip of some sort perhaps one that someone's made on a 3D printer or has found one that fits/clips onto the center windshield support in order to hold/contain wires. I run two fans mounted near the rear view mirror, that plug into the cigarette lighter and the wire runs up the center support of the windshield. I've use tape,velcro hot glue and all have failed in the heat of Summer. I was looking for some sort of clip as there is a edge on the center support that seems like a cover or small clip could latch onto. This would also be helpful for anybody that has a GPS or window mounted radar detector to contain or hide the wires.. Anybody come up with a solution? I know I could always hardwire the fans and run the wire someplace behind the top cap but I was looking for something a little more straightforward and less permanent
'78 Palm Beach. car nut new to RV'ing 26 ft. 403 rebuilt in 2018, rebuilt tranny in 2014, Dave Lenzi knuckles & hubs, yada yada yada on ION wheels,Green Brady Bunch stock
David Martin on Facebook
[Updated on: Mon, 05 August 2019 18:41] Report message to a moderator |
|
|
|
GMCforum
Search
Help
Register
Login
Home
