Iso pads installation [message #342394] |
Tue, 09 April 2019 05:24 |
tgeiger
Messages: 518 Registered: February 2006 Location: kansas city
Karma:
|
Senior Member |
|
|
Whoo boy, finally getting the iso pads put in. Ended up just cutting the carriage bolts out, hope to find a replacement bolt that may be stainless steel or zinc. Will need to loosen the donut bolts at the front and back of coach. Hoping I will not need to replace them. Will do the jack stands and lower air bag pressure on one side at a time to lessen the frame uplift pressure. I saw the # 10 Tek SS screws being used. Would 3/4" length be enough or should I do 1" length?
Thanks,
Tom
76 Eleganza 2
KCMO
Tom Geiger
76 Eleganza II
KCMO
|
|
|