GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Re: [GMCnet] Replacing rear wheel cylinder
Re: [GMCnet] Replacing rear wheel cylinder [message #340174] Fri, 18 January 2019 19:43 Go to previous message
BobDunahugh is currently offline  BobDunahugh   United States
Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA
Karma:
Senior Member
You can change wheel cyl without pulling the brake shoes off. Very simple, and quick. You can't re flare the original tubing. It's too hard/brittle. It will just crack. Harbor Freight has a tubing bender that can make tight bends. You can reproduce that brake line perfectly. You MUST support the replacement line as GM did. Bob Dunahugh 78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: John L.
Next Topic: Fuel Tank 5/16 inch Vent Line
Goto Forum:
  


Current Time: Sat Sep 21 09:00:33 CDT 2024

Total time taken to generate the page: 0.00637 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software