Onan rear bearing [message #340060] |
Thu, 10 January 2019 19:50 |
Tilerpep
Messages: 404 Registered: June 2013 Location: Raleigh, NC
Karma:
|
Senior Member |
|
|
I bought an Onan 6K to replace the one missing the board, starter, exhaust, etc.
On the rear there is a visible bearing, the dust cover is gone and there only seems to be about half as many ball bearings in it as there should be. Onan ran fine, but seems I should address this while out. Searching forum archives I found someone asked for this part number as well, but didn't find any reply. Also found a picture of it for reference.
http://www.gmcmhphotos.com/photos/onan-pictures/p16879.html
Part numbers and any tips, instructions or whatever are appreciated. As well as what else I should check over before re-install. It has been de-carboned and the pertronix ignition put on.
Thanks
Tyler
1975 Glenbrook, 1978 Royale rear bath
Raleigh, NC
|
|
|