[GMCnet] Macerator quick disconnect fittings. [message #336418] |
Mon, 27 August 2018 11:02 |
powwerjon
Messages: 849 Registered: March 2013
Karma:
|
Senior Member |
|
|
I had made a comment earlier this week that Northern Tool had discontinued these parts. I called them this morning and determined that only the dust cap and gasket had been removed from the catalog.
You need this item on one end of your 1” hose section:
¥ou need this item on the other end of your 1” hose section:
This would complete one section of hose.
For the connector at the coach you actually need 4 different parts to make that happen.
See this picture:
The part needed on the back side of the mounting plate which I made mine out of a piece of a polypropylene cutting board that you can buy at Walmart or a store of your choice.
For the front you need the following:
This are screwed together thru the hole in the polypropylene mounting board. As an example I have listed one available and most are3/8 to 1/2 inch thick.
or
http://tinyurl.com/yak7qem8
The parts that are no long in stock are the Dust and spare gaskets.
The Dust cap is available from Norwesco: Norwesco.com It is now there part number 61266 I have no pricing for that. Need to go to the website.
The spare gasket for the cap is now available from Apache: phone# 866-757-7816 and their part# is 97433098
As for hose I get mine from a hose supply house, or you can purchase it at Lowes:
or
http://tinyurl.com/ya3vur5y
I will try and get better picture of the current layout I used and how I store the hose.
J.R. Wright
GMC Great Laker MHC
GMCGL Tech Editor
GMC Eastern States Charter Member
GMCMI
78 GMC Buskirk 30’ Stretch
75 GMC Avion (Under Reconstruction)
Michigan
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|