Two different spindles on the back of my 77 PB [message #334845] |
Mon, 09 July 2018 10:50 |
|
RF_Burns
Messages: 2277 Registered: June 2008 Location: S. Ontario, Canada
Karma:
|
Senior Member |
|
|
So I have the rear hubs off to do the rear bearings. When cleaning up the retaining nuts I noticed the ones from the drivers side are larger than the passenger side. I measured the spindle size where the bearings go and they are the same 1.03" and 1.63" approx. on all 4.
The thread size diameter measures 0.73" on the passenger side and 0.84 on the driver's side. Obviously the spindles on one side have been changed at some point. Bearing size seems the same.
Can anyone shed some light on the two different sizes?
Thanks
Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC. 1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that
[Updated on: Sun, 16 December 2018 08:34] Report message to a moderator
|
|
|