GMCforum: GMCnet » Main black tank valve not completely closing

Home » Public Forums » GMCnet » Main black tank valve not completely closing

Show: Today's Messages :: Polls :: Message Navigator

Main black tank valve not completely closing [message #334435]

Mon, 02 July 2018 13:21

RF_Burns

Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada

Karma:

Senior Member

So my black tank valve doesn't completely close. I can't get the retaining clips to snap over the handle. I'd say its less than 1/4" open, although it doesn't seem to leak. I'm thinking there is some crud built-up in the end slot where the blade closure fits in.

Is it possible to remove the valve's shut-off blade out of the side of the valve so I can get a stiff wire in there to clean it? I'm hoping I don't have to pull it all apart to get to it. Rolling Eyes

Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that

Report message to a moderator

[Message index]

		Main black tank valve not completely closing By: RF_Burns on Mon, 02 July 2018 13:21
		Re: [GMCnet] Main black tank valve not completely closing By: emerystora on Mon, 02 July 2018 14:02
		Re: Main black tank valve not completely closing By: Matt Colie on Mon, 02 July 2018 14:16
		Re: Main black tank valve not completely closing By: RF_Burns on Mon, 02 July 2018 14:25
		Re: Main black tank valve not completely closing By: JohnS on Mon, 02 July 2018 17:57
		Special Note!! Main black tank valve not completely closing By: Matt Colie on Tue, 03 July 2018 08:54

Previous Topic:	Article from FB from Mac the Fire Guy on Propane
Next Topic:	[GMCnet] One thing leeds to another.

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Nov 18 06:54:41 CST 2024

Total time taken to generate the page: 0.00975 seconds