GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Engine and Transmission install in an open clip
Engine and Transmission install in an open clip [message #333392] Tue, 12 June 2018 09:57 Go to previous message
Matt Colie is currently offline  Matt Colie   United States
Messages: 8547
Registered: March 2007
Location: S.E. Michigan
Karma:
Senior Member
I am hoping someone has experience that will be helpful. I have the clip out, the engine is about done, but I also plan to lift the transmission out to do the filter and inspect the pinion bearing (as that has been recently an issue for some).

Will I be better off if I reinstall the engine and transmission from the top as a unit, or as two separate pieces?

I'm getting there, but it is all going more slowly than I would like. (Of Course)

Matt

Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Eldorado 500 engine. Pick it up at the GMCMI event in Iowa
Next Topic: [GMCnet] Building the GMC to sell. Shimming the rear suspention.
Goto Forum:
  


Current Time: Fri Nov 15 20:21:54 CST 2024

Total time taken to generate the page: 0.00633 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software