[GMCnet] Tid Bit. Getting a wire fed in tight small places. [message #331503] |
Sat, 28 April 2018 23:02 |
BobDunahugh
Messages: 2465 Registered: October 2010 Location: Cedar Rapids, IA
Karma:
|
Senior Member |
|
|
Ever tried to get a wire a short distance under carpet. Or thru a double panel of the floor, or bulk head. Drill the hole large enough to stick a long straw thru your hole. ( Gas stations have the longest straws for their soft drinks. ) Feed the wire into the straw. Pull the straw out the other end after feeding the wire to the other end of the straw.. Or leave the straw to protect the wire from vibration. I needed to feed a wire under our rubber backed carpet. ( Was putting the EFI engine control module under the seat. ) Slid the straw under the carpet. Then just slid the wire thru the straw. Again. Left the straw under the carpet. Used that straw 7 months later to add another wire. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|