GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Where to mount the Ramco mirror controller
Where to mount the Ramco mirror controller [message #330077] Fri, 16 March 2018 18:07 Go to previous message
Scott Nutter is currently offline  Scott Nutter   United States
Messages: 782
Registered: January 2015
Location: Houston/San Diego
Karma:
Senior Member
Any good ideas on where to mount the Ramco mirror controller switch with doing the least amount of damage? I was thinking just forward of the height controller panel on the drivers side panel.
Any other ideas?
Thanks, scott

Scott Nutter 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI Houston, Texas

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Subject: Need names of who's inrersted in Futureliner tour at the September GMCMI Rally in Amana Iowa.
Next Topic: Dash ash tray
Goto Forum:
  


Current Time: Wed Mar 12 20:57:21 CDT 2025

Total time taken to generate the page: 0.02248 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software