[GMCnet] Floor not level [message #329717] |
Tue, 06 March 2018 10:42 |
Shane Grass
Messages: 5 Registered: October 2017
Karma:
|
Junior Member |
|
|
Has anyone experienced a slight crown on their plywood floor and, if so, how did you attempt to correct it? I just pulled the vinyl sticky tiles off the floor and noticed maybe a 1/2 in difference in height between the plywood floor at the entrance and the middle of the RV (then I could tell from looking straight on that it curves back down under the stove on the driver side).
Never really noticed it so much until I pulled the aluminum transition strips that are screwed down at the entrance and hallway.
I did a little research online and found some people applied DAP flexible floor leveling, but that doesn’t address any possible problem... I’m thinking a water leak in the past might have caused the plywood to swell, but I’m not certain. My main concern is that the bowing is directly above one of the fuel tanks. No issues with fuel delivery to the engine.
Thanks for any advice!
Shane
‘76 Royale
Ocala FL
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|