| 45 Amp Intelli-Power Converter Conversion Questions [message #313928] |
Wed, 01 March 2017 08:57  |
pnbarber
Messages: 11
Registered: June 2016
Location: Raleigh, NC
Karma:
|
Junior Member |
|
|
I posted the following at the back of the recent converter discussion but I thought I might get a response quicker if I started a new thread.
First a little background on the coach, it is a mid 90's Clasco conversion and has all the wiring connected to a distribution panel and then to power circuit panel. The old converter is under rear cabinets and only accessible from the side and I will be reinstalling the new one there.
The linked photos shows my current converter connections. I identified the red power and ground wires that will connect to the new converter and the receptacle for the plug. I haven't removed it so I don't know for sure if it has internal fuses but I've included an interior shot for discussion.
http://www.gmcmhphotos.com/photos/old-converter/p62204-old-converter.html
http://www.gmcmhphotos.com/photos/old-converter/p62205-inside-old-converter.html
If a fuse is needed, is a 40 Amp inline type adequate protection or is there another type that I should get. Also, the new converter instructions indicate a separate chassis ground is required which I will install.
Thanks in advance.
P. Barber
Raleigh, NC
1978 GMC Royale - 1995 Clasco Upgrade
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
