Sending unit test [message #311707] |
Fri, 30 December 2016 20:57 |
Atom Ant
Messages: 170 Registered: October 2016 Location: Austin, TX
Karma:
|
Senior Member |
|
|
Finally got the time to drop the tanks on the coach! I got the sending units out and tested them. I get a proper 3-93 ohms reading on one. On the other, I cannot get a reading when I put the probe to the positive terminal, but do get a reading if I probe under the plate, where the wire attaches to the terminal on the bottom. The reading isn't 3-93, but 90-ish to 180 ish, so still 90 ohms. Is this a problem? If one were to want to replace the terminal, what would be the best way to do so? I know I there's only the need for one working unit, but if it's not too much trouble, I'd rather have two working senders.
I'll have more questions coming, as I get these tanks cleaned up and re installed.
Thanks everyone.
1976 Palm Beach
Austin, TX
|
|
|