Engine water pump supplier [message #306888] |
Sat, 10 September 2016 17:14 |
Scott Nutter
Messages: 782 Registered: January 2015 Location: Houston/San Diego
Karma:
|
Senior Member |
|
|
I've been through all the previous post for the water pump model numbers. Unfortunately those model numbers don't seem to be avail with the cast iron impeller, with the backing, at 4 1/4" diameter. A lot of stamped impellers but their diameters look to be less than 4".
Any suggestions on where to find a high quality water pump to fit the 455? Or are they no longer available, so go Chinese? I hope not....
Thanks, Scott.
Scott Nutter
1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI
Houston, Texas
|
|
|