Onan Test Run [message #302628] |
Sun, 26 June 2016 00:47 |
Adrien G.
Messages: 474 Registered: May 2008 Location: Burns Flat, OK 73624
Karma:
|
Senior Member |
|
|
Need help.
The Onan has been taken out of the MH compartment for cleanup of oil leaks,
R & R rear armature bearing, general maint, upgrades, and paint.
Would like to bench start the unit to check on oil leaks, voltage output,
carb adjustment and ? before putting it in.
How secure does it need to be to do this, and is a light bulb enough of a load on the gen
to check output?
Your comments and ideas, welcomed.
Adrien & Jenny Genesoto
75 Glenbrook (26-3) Mods LS3.70 FD / Reaction Sys / 80mm Front&Intermidiate / Hydroboost / 16" Tires / Frame Rebuild / Interior Rebuild
Yuba City,Ca. Text 530-nine-3-three-3-nine-nine-6
|
|
|