[GMCnet] Restoration. Found some nice screws a Lowe's [message #298649] |
Tue, 05 April 2016 01:36 |
BobDunahugh
Messages: 2465 Registered: October 2010 Location: Cedar Rapids, IA
Karma:
|
Senior Member |
|
|
Needed screws to put the white front, and back ABS plastic panels up that would look nice.They have some white, aluminum , round headed squair drives that look nice. Some plated large head flat head phillips self-drilling screws. These I found work great for the paneling in hidden places. As they didn't split out the edges of the paneling. Then some decorative round head square drive screws for the cabinets. All wall panels including the cedar closet are up from the door to the rear. Both sides. Tomorrow. Insulate the ceiling. Then install all the new ceiling panels that I have premade, and finish coated. Drill the 4 inch holes for the 8 ceiling LED cann lights. I have 17 - 12 volt wires, and coax that need a hole to have these wires come out of the ceiling to the electrical center. Then 10 - 110 volt wires that come out of the walls. These 110 volt lines are going to the 9 circuit breakers in the Square D panel. Great to see big parts going in at last. Bob Dunahugh78 Royale Mouse House.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|