[GMCnet] Restoration. LP leak hazards to think about. [message #297512] |
Thu, 17 March 2016 01:38 |
BobDunahugh
Messages: 2465 Registered: October 2010 Location: Cedar Rapids, IA
Karma:
|
Senior Member |
|
|
When I started this project. I made the decision that I was going to closely check everything out. I'm now well into putting things back in. And now it's time to install the LP components. I've found the copper pipe with brass fittings have all been tight, and in great condition. And will there out. I polished the ones inside that Linda can see. I did clean the grounding wire clamp. As it was very corroded. Sand blasted the stationary tank to check for rust pits. Tank passed. Replaced the turn on/off valve. As it leaked. The 2 stage regulator was fine. But got a new one from Jim K at Applied. I wasn't at all pleased with the condition of rubber hose between the copper pipe, and regulator. So these item might be somethings to look at for safety sake.Bob Dunahugh78 Mouse House
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|