[GMCnet] FiTech looks like the real deal [message #292301] |
Wed, 16 December 2015 08:53 |
glwgmc
Messages: 1014 Registered: June 2004
Karma:
|
Senior Member |
|
|
Hi Rob,
Yes, an adapter plate is needed since the four square pattern throttle valves do not line up with the two small and two large holes in the top of our spread bore intake manifold. The mounting tab holes do line up so it will bolt on without an adapter, but the throttle valves would not open properly. I happened to use one from NAPA because it was thinner than the one from Holley.
Jerry
Jerry Work
The Dovetail Joint
Fine furniture designed and hand crafted in the 1907 former Masonic Temple building in historic Kerby, OR
glwork@mac.com
http://jerrywork.com
==============
Message: 1
Date: Wed, 16 Dec 2015 13:21:14 +1100
From: "Robert Mueller"
To:
Subject: Re: [GMCnet] FiTech EFI looks like the real deal
Message-ID:
Content-Type: text/plain; charset="us-ascii"
Jerry,
Excellent report, THANKS!
One question, is an adapter required to fit the FiTech injection system on the Q-Jet manifold?
Regards,
Rob M.
The Pedantic Mechanic
================
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Jerry & Sharon Work
78 Royale
Kerby, OR
|
|
|