GMCforum: GMCnet » [GMCnet] The Restoration.Plywood under right seat. Simple to replace

Home » Public Forums » GMCnet » [GMCnet] The Restoration.Plywood under right seat. Simple to replace

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] The Restoration.Plywood under right seat. Simple to replace [message #289204]

Thu, 22 October 2015 23:21

BobDunahugh

Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA

Karma:

Senior Member

I've seem 3 GMC's with this plywood floor section in poor condition. After I got the front seats out. I found the floor plywood that's next to the outside wall vary soft. There are 7 pop rivets holding that floor section in place. I drilled the rivets out. And that floor section lifted out vary easy. So I'm going to get some marine plywood. And make that panel on my table saw. Then apply some rubberized under coating to the bottom side. Then I'm going to put down some epoxy paint to seal the entire floor. If anyone wants some photo's. Let me know by privet E-mail.Bob Dunahugh78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]

		[GMCnet] The Restoration.Plywood under right seat. Simple to replace By: BobDunahugh on Thu, 22 October 2015 23:21
		Re: [GMCnet] The Restoration.Plywood under right seat. Simple to replace By: jimk on Fri, 23 October 2015 00:45
		Re: [GMCnet] The Restoration.Plywood under right seat. Simple to replace By: emerystora on Fri, 23 October 2015 01:04
		Re: [GMCnet] The Restoration.Plywood under right seat. Simple to replace By: appie on Fri, 23 October 2015 02:03
		Re: [GMCnet] The Restoration.Plywood under right seat. Simple to replace By: Mr ERFisher on Fri, 23 October 2015 05:51

Previous Topic:	GMC Sighting
Next Topic:	[GMCnet] New GMCMH Listing!

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Oct 08 05:31:26 CDT 2024

Total time taken to generate the page: 0.01121 seconds