[GMCnet] Spare Wheel Mount [message #285882] |
Wed, 26 August 2015 08:44 |
Peter Garry
Messages: 138 Registered: July 2011
Karma:
|
Senior Member |
|
|
Ah Ha. The PO had a spare Steel) with 2 extra holes drilled and 2 Hex screws to hold the wheel on. There are 2 short studs that appear to have been cut to about 1/2” long. Measuring these shortened studs they are are about 5.5 inches on centre, the Alcoa holes are 6.5 inches.
So it as I thought, I will be fabricating a new plate with studs placed correctly.
It was a long shot, just thought I would ask.
thanks
Peter Garry
73 - 23ft
Calgary, Alberta
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|