Re: [GMCnet] propane tank gauge [message #281607] |
Mon, 06 July 2015 23:13 |
Tom Whitton
Messages: 235 Registered: February 2004 Location: Paducah, KY
Karma:
|
Senior Member |
|
|
I had the propane tank out to repair a disconnected water line and accidently broke the gauge on the side of the propane tank. The bottom part of the old gauge is still on the tank. I have a replacement. Could someone tell me how to go about replacing the damaged gauge? There are two mounting tabs, one center upper and one center lower. The gauge is held in place with screws through these tabs. My tank is almost full of propane. To replace the gauge I started to remove the two screws. When they were about half way out I heard a slight hissing noise from gas leaking out and quickly retightened them. I was apprehensive about do this job anyway. Maybe I imagined the sound but I don't want to take a chance. Can anyone help? Obviously, my knowledge in this area is deficient.
Tom Whitton
26 foot updated GMC
Paducah, KY
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|