fridge install [message #280479] |
Mon, 22 June 2015 10:06 |
lqqkatjon
Messages: 2324 Registered: October 2010 Location: St. Cloud, MN
Karma:
|
Senior Member |
|
|
Time to go to a LP fridge. a minor problem with the norcold, and a craigslist find, made it the new project to get done.
I pulled out my original Norcold yesterday. I picked up a nice looking Dometic rm2652 for $300.
I have been searching out the photo site, and trying to get my ideas all in place for the installation. I have seen rick Drummond's, Carls, and a couple others.
It is my plan to pull the rear panel out,(dry rotted a little bit, and looks like i need the 1" more clearance at the top). paint the wood with some fire retardant paint(Telco stuff I have at work just because it is easy and available). Then line the compartment with reflectix.
it looks like I will have to cut 1" to the top side of the front trim to get the fridge to fit, and I hope I can squeeze an inch or so on the top rear of the compartment, so I do not have to shim it out into the hallway. taking a quick skim, I also was looking at the instructions on the dometic rm2652, and it seems there is not much of a clearance requirements, as the norcold installs I looked at. I don't see any maximum clearance, just minimum(0").
I also bought the valtera 12v thermostatically controlled fan, I plan to mount in the roof vent.
so if there are other photo's or ideas, let me know.
Jon Roche
75 palm beach
EBL EFI, manny headers, Micro Level, rebuilt most of coach now.
St. Cloud, MN
http://lqqkatjon.blogspot.com/
|
|
|