[GMCnet] Onan Question [message #279520] |
Wed, 10 June 2015 13:23 |
Arthur Mansfield
Messages: 290 Registered: April 2010
Karma:
|
Senior Member |
|
|
All I know for sure is there is oil going all over the place when I run the generator. I have pulled the fly wheel. The coils that are in the fly wheel do not have any oil on them.
Need to replace the pressure switch while I have the fly wheel off. Is this a special pressure switch?
I need to remove the crank shaft seal. How is the best way to remove the seal.
Art & Doris
Decatur AL
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|