Aluminum Radiator install question [message #271918] |
Fri, 13 February 2015 20:23 |
Hal StClair
Messages: 971 Registered: March 2013 Location: Rio Rancho NM
Karma:
|
Senior Member |
|
|
Started to install my aluminum radiator and have run into a little glitch. Instructions say to move the lower passenger side mount bracket as I did but after setting the radiator in place it throws the upper bracket out of alignment. Because the upper bracket has an offset at the filler neck, there is no room to move the upper bracket outward. I can move the drivers side upper bracket, move the whole bracket toward the passenger side an inch and add to the whole upper frame on the drivers side about an additional inch. Then trim the passenger side the inch I added. Seems something isn't right here, any thoughts?
Hal
"I enjoy talking to you. Your mind appeals to me. It resembles my own mind, except you happen to be insane."
1977 Royale 101348,
1977 Royale 101586, Diesel powered,
1974 Eagle Bus 45',w/slideout,
Rio Rancho, NM
|
|
|