| [GMCnet] Never assume anything [message #269789] |
Fri, 16 January 2015 15:14  |
glwgmc
Messages: 1014
Registered: June 2004
Karma:
|
Senior Member |
|
|
The new board came today. I installed it, pressed the start switch and the Onan sprang to life. As soon as it warmed up a minute or so it ran evenly, put out 125vac with no load and 115VAC under load. So, the combination of the module plus a new board and it sounds better and smoother than it ever has. Good use of $250 or so. The new board with the pig tail soldered on looks like a much higher quality piece that the stock board with all those push on connectors ever did. Thanks to all who offered advice and suggestions. My suggestion is to make sure the polarity on the coil is correct before hooking up the module!
Jerry
Jerry Work
The Dovetail Joint
Fine furniture designed and hand crafted in the 1907 former Masonic Temple building in historic Kerby, OR
Visitors always welcome!
glwork@mac.com
http://jerrywork.com
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Jerry & Sharon Work
78 Royale
Kerby, OR
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
