| Re: [GMCnet] Problem with my Electrolevel I [message #264812] |
Sat, 25 October 2014 17:42  |
Ray Erspamer
Messages: 1707
Registered: May 2007
Location: Milwaukee Wisconsin
Karma:
|
Senior Member |
|
|
I had this exact same problem last summer, everything operated fine but it would not auto lower. The outside height sensors had failed. I put in new ones and nearly instantly they failed. So I ran a new 12 volt wire to power the solenoid valves through relays. The system wiring now activates only the relays, all has been fine since. Still not sure what was going on, a voltage spike or ???? But the system power was frying the height sensors. I cooked 4 of them, when I went to 5 & 6 I installed the relays. If you figure anything else out, please let me know.
Sent on a Sprint Samsung Galaxy S® III
-------- Original message --------From: Larry Date:10/25/2014 4:59 PM (GMT-06:00) To: gmclist@temp.gmcnet.org Subject: [GMCnet] Problem with my Electrolevel I
All functions work on my Electrolevel I ACCEPT, when the coach is high, and I put the middle switch in AUTO, it does not level out automatically. It
will automatically level if the coach is low. If it is low, I just set the switch to AUTO and it comes up to level and stops at it's preset point.
Bot UP and DOWN switches work to manually raise or lower. I have checked out the "AUTO/HOLD" switch and it is functioning properly. Any Ideas?
--
Larry
78 Royale w/500 Caddy
Menomonie, WI.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ray Erspamer
78 GMC Royale Center Kitchen
403, 3.70 Final Drive
Holley Sniper Quadrajet EFI System,
Holley Hyperspark Ignition System
414-484-9431
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
