[GMCnet] Need help with carb tubing.. [message #255666] |
Wed, 16 July 2014 21:22 |
Daniel DeLuca
Messages: 120 Registered: June 2014
Karma:
|
Senior Member |
|
|
Hello All,
I have returned from vacation in Oregon to NJ and am continuing to get the coach into running shape. I have dropped the tanks and replaced all fuel lines, replaced the fuel pump and put on new oil cooler lines. I have given the carb a very light rebuild. (Replaced float and valve, set float hight and a few other things on the top end.) I almost have it back on but one of the pictures I took to help me reassemble was not clear and I need help routing one of the vacuum lines.
The pictures are here
http://imgur.com/a/kSkch
The line I am confused about is the upper left tube leaving the carb if you are facing the windshield. It appears to come from a ’T' but one end of the ’T’ is missing. So I need to know where each end of the ’T’ should lead to. Any help would be greatly appreciated. After I get the carb on its time to start the beast up. Assuming all is well, I will do the breaks, bearings and the shocks before turning my attention to the inside. Its been fun so far.
Dan DeLuca
78’ Eleganza II
Allentown NJ
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|