ONAN Head Experience [message #254788] |
Tue, 08 July 2014 23:52 |
captjack
Messages: 271 Registered: February 2010 Location: Sebastopol, California
Karma:
|
Senior Member |
|
|
I installed a Pertronix electronic ignition for which I fabricated the mounting. I also decided to de-carbonize the heads. They deserved it!
I retightened the head bolts using a torque wrench to the proper settings. Some time later I noticed what I thought was an exhaust leak which showed up when the ONAN was powering two generators. I finally decided to track it down and found that the head bolts were now loose, some capable of being tightened almost by hand. I really don't understand why, since I was also reusing the old head gasket. But retightening them solved the problem and the generator is now relatively quiet again.
So, head bolts should be tightened after a few hours of operation if the heads are removed.
Jack Christensen - K6ROW,
'76 Glenbrook/Clasco - "The Silver Bullet",
Sebastopol, CA
|
|
|