[GMCnet] Fwd: CAD 500 QUADRAJET? [message #252388] |
Tue, 17 June 2014 16:56 |
scott cowden
Messages: 170 Registered: February 2004
Karma:
|
Senior Member |
|
|
Sent to dick Paterson. Answer below.
Sent from my iPhone
Begin forwarded message:
> From: "Dick Paterson"
> Date: June 17, 2014 at 5:52:56 PM EDT
> To: "scott cowden"
> Subject: Re: [GMCnet] CAD 500 QUADRAJET?
>
> the cad has a side feed not front so that would take any chev big block q-jet with the same inlet orientation (again to get me home) driveability aside
> ----- Original Message -----
> From: scott cowden
> To: Dick Paterson
> Sent: Tuesday, June 17, 2014 5:34 PM
> Subject: Fwd: [GMCnet] CAD 500 QUADRAJET?
>
>
>
> Sent from my iPhone
>
> Begin forwarded message:
>
>> From: James Hupy
>> Date: June 17, 2014 at 5:14:51 PM EDT
>> To: gmclist@temp.gmcnet.org
>> Subject: [GMCnet] CAD 500 QUADRAJET?
>> Reply-To: gmclist@temp.gmcnet.org
>> Who is running a Quadrajet on a Cad 500 in a GMC motor home that knows the
>> combination of jets, needles, etc. close to correct for this application?
>> We are in Joplin, Mo at the airport by the side of the road. Tow truck
>> coming for a tow to Oklahoma City to camping world. They put a reman for a
>> 368? Cid that was 2 years newer than the engine which is a 76. Correct part
>> number would be helpful also as I am flying blind here without reference
>> books, etc.
>> Coach belongs to John and Deb Harper
>> Jim Hupy
>> Route 66 road show.
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|