Methods to weigh front wheels separately [message #251036] |
Fri, 30 May 2014 15:17 |
Tilerpep
Messages: 404 Registered: June 2013 Location: Raleigh, NC
Karma:
|
Senior Member |
|
|
Hi all, with drive train shaping up, turning attention to suspension. I know my front ride height is an inch too low. It is level, meaning both sides are an inch too low, with rear set at correct height with air suspension. Dave Lenzi has been a big help to talk to and recommended that I actually weigh the load on each front wheel to aim for balance as I adjust it. I haven't found a shop around Raleigh that has any capacity to do each side separately. Do you all have recommendations for a place, person, or a club that has done this? There are some folks on the black list that have noted if they have a bearing tool (something I am going to ask for next/soon) but I haven't seen anyone make note of a scale. If appropriate you can respond on the forum, or PM me if that would be better.
Thanks,
Tyler
1975 Glenbrook, 1978 Royale rear bath
Raleigh, NC
|
|
|