GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Lug nut / Wheel nut Torque
[GMCnet] Lug nut / Wheel nut Torque [message #249294] Fri, 09 May 2014 22:37 Go to previous message
USAussie is currently offline  USAussie   United States
Messages: 15912
Registered: July 2007
Location: Sydney, Australia
Karma:
Senior Member
G'day,

For clarity I will refer to the nuts that hold the wheels onto the hubs as LUG NUTS; they are 9/16 inches diameter and 18 threads
per inch (TPI).

The GMC Maintenance Manuals X-7425, X-7525, X-7625, and X-7725 all specify to tighten the lug nuts to 250 ft lb and NOT to lubricate
the nuts or studs. I checked the Service Bulletins and cannot find any information noting to lower the torque. It has been noted on
the GMCnet that torquing the lug nuts repeatedly to 250 ft lb torque can stretch the wheel studs and cause them to break. It has
been noted to lower the torque to 150 ft lb and lubricate the threads.

I suggest we discuss this and come up with recommendations based on our discussion.

Alcoa wheel lug nuts are a done deal as the lug nuts have 140 ft lb stamped into them.

Regards,
Rob M.
Sydney, Australia
AUS '75 Avion - The Blue Streak TZE365V100428
USA '75 Avion - Double Trouble TZE365V100426




_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist



Regards, Rob M. (USAussie) The Pedantic Mechanic Sydney, Australia '75 Avion - AUS - The Blue Streak TZE365V100428 '75 Avion - USA - Double Trouble TZE365V100426
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Dumb Move
Next Topic: Hot Water Heater feed lines
Goto Forum:
  


Current Time: Tue Oct 15 03:17:46 CDT 2024

Total time taken to generate the page: 0.01812 seconds