Without a hitch [message #246133] |
Wed, 02 April 2014 06:57 |
|
SeanKidd
Messages: 747 Registered: June 2012 Location: Northern Neck Virginia
Karma:
|
Senior Member |
|
|
Took some time off from my fuel tank/hard line install to finish my 3.70 final drive and install my new through the bumper receiver. All of what I've read, this installation goes off "without a hitch"... Once I removed my spare tire carrier and 1/2 inch plate steel welded "shelf" that was bolted to the frame, I placed my hitch on my jack and put it in place...nothing lines up...my coach is an early '73 #317...what is the consensus, redrill the frame? Then I have 16 holes in it...and retrofit the carrier? Were these holes factory? Any other history of wider than normal mounting points?
Sean and Stephanie
73 Ex-CanyonLands 26' #317 "Oliver"
Hubler 1-Ton, Quad-Bags, Rear Disc, Reaction Arms, P.Huber TBs, 3.70:1 LSD Honda 6500 inverter gen.
Colonial Travelers
[Updated on: Thu, 03 April 2014 07:40] Report message to a moderator
|
|
|