GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Onan - No AC Outpus
Onan - No AC Outpus [message #245891] Mon, 31 March 2014 14:32 Go to previous message
Steve is currently offline  Steve   United States
Messages: 506
Registered: September 2013
Location: East Greenville, Pa
Karma:
Senior Member
I had been feeling pretty good about my Onan as I had it running really well thanks to many here on the net. Well today, no AC output. Worked fine a week ago but today no AC. I am not aware of anything I did different or unusual.

I went to Gene Fisher's site and read up on the issue. Everything seemed to point to the Bridge Rectifier (BR). I removed my BR, carefully noting the orientation and labeling each of the wires.

I had a spare BR so I thought I would swap it out. It is an aftermarket NTE5328 that has a different orientation of the pins so I had to modify the plastic base by drilling 1/4 inch holes so the wires can align properly with the pins.

Here is my problem. I was very careful to note the orientation of the original BR and carefully label all the wires. This is important because the BR can be inserted four different ways, but only one way works. I am certain that I can get the old BR back in properly but I don't know how to properly orient the new BR.

The only markings on both BR's is some numbering on one side. The new one is numbered NTE5328. I oriented the new BR with the numbering in the same position or orientation of the original, but I don't know if that is necessarily correct.

I did install it that way and started the Onan but still no AC being produced. I don't know if it was a good BR or if I have oriented it incorrectly? Any help or ideas would be greatly appreciated.

I did measure the voltage across control board pins 8 and 11 and I am only getting 2.3 volts. I think my next step will be to disconnect the voltage regulator as I understand it is not required and could cause problems if it failed.

How do I know how to properly align or orient my new BR?
Is there anything else I should be trying?



1978 GMC Royal
Eastern Pennslyvania
1968 Chevrolet C20 396 Camper Special
1969 Chevrolet C20 Camper Special
1985 Buick Electra Park Avenue
1992 Camaro 25th Anniversary Heretage Edition Black
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Seeking Battery Systems Advice
Next Topic: lower door hinge
Goto Forum:
  


Current Time: Thu Sep 26 13:00:22 CDT 2024

Total time taken to generate the page: 0.00903 seconds