steering timing mark [message #243281] |
Thu, 13 March 2014 07:36 |
skip2
Messages: 544 Registered: September 2011 Location: Winter Haven,FL (center o...
Karma:
|
Senior Member |
|
|
Don't intend to rehash a previous discussion that had a lot of capital letters but a timing mark was mentioned on the top of the steering shaft. Is that timing mark just a mark that looks like some one took a chisel and popped the end of the shaft to mark TDC or 12:00, I assume this is critical for the turn signal cancellation mechanism, also does the actual orientation of the u-joints on the lower shafts prove to be critical since it looks like there is about 6 positions the slider part of the shaft could bolted to the upper connector? Thanks for any comments.
Skip Hartline
74 Canyon Lands, FiTech,
3.7 FD LSD, Manny Tranny,
Springfield Distributor,
2001 Chevy Tracker Ragtop Towd
|
|
|