[GMCnet] Macerator outlet hose [message #243250] |
Wed, 12 March 2014 21:50 |
glwgmc
Messages: 1014 Registered: June 2004
Karma:
|
Senior Member |
|
|
Waaaaay better than was done on the Clasco..........
Jerry
Jerry Work
The Dovetail Joint
Fine furniture designed & hand crafted
in the 1907 former Masonic Temple building
in historic Kerby, OR
http://jerrywork.com
,,,,,,,,,
Jerry,
Here's a photo of how JimB and I installed the macerator under Double Trouble:
http://www.gmcmhphotos.com/photos/g6528-macerator-install.html
The 1" ID macerator tube is clear and I don't have a cap on the end because when I'm done macerating I lift the 1" ID tube starting
at where I comes through the rear cross member and work my way towards the end. I can see through the tube and watch the residual
contents as they travel through the tube. When it is empty I lift it out of the dump hole, give it a bit of a shake and feed it back
into the storage tube along the bottom of the frame.
Does this procedure sound somewhat familiar to any of the guys that read this? ;-)
Regards,
Rob M.
Sydney, Australia
AUS '75 Avion - The Blue Streak TZE365V100428
USA '75 Avion - Double Trouble TZE365V100426
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Jerry & Sharon Work
78 Royale
Kerby, OR
|
|
|