Back suspension height adjustment [message #242889] |
Mon, 10 March 2014 06:44 |
tgeiger
Messages: 518 Registered: February 2006 Location: kansas city
Karma:
|
Senior Member |
|
|
Just want to check to see if I got this right. I've had a leak down issue with my passenger side rear suspension quad bags. I got that leak fixed I beleive. The other issue is the paasenger side seemed to be lower than the driver side. I put the Autolevel mode on and when it shut off...the passenger side measured 33" to the rear wheel well skirt seam and the driver side measured 35"...so a difference of 2"...I read the manual and it mentioned the leveling arm adjustment nut. It said to loosen it and make the coach level..34" to the seam on both sides...which measure roughly 11 3/4" at the back slot in the main frame, then re-tighten. So my question is, did I get this right. Will this now correctly level at 34" on both sides? Seemed to be pretty straight forward to make this adjustment.
Tom Geiger
76 Eleganza II
KCMO
|
|
|