GMCforum: GMCnet » [GMCnet] HF Torsion bar unloader

Home » Public Forums » GMCnet » [GMCnet] HF Torsion bar unloader

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] HF Torsion bar unloader [message #228399]

Mon, 04 November 2013 10:37

Jp Benson

Messages: 649
Registered: October 2011
Location: Fla

Karma:

Senior Member

Bought this for it's intended purpose. i.e. Ball joint service. Doesn't
work for GMC ball joints. At least I was able to use it on my torsion
bars after making a couple of pieces. A little bulkier than the purpose
built t-bar tools but it does work. Also useful for control arm bushing
service.

http://www.gmcmhphotos.com/photos/g6343-front-clip-april-2013.html

JP
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

[Message index]

[GMCnet] HF Torsion bar unloader

By: Jp Benson on Mon, 04 November 2013 10:37

Previous Topic:	[GMCnet] Motion Sickness Remedy
Next Topic:	[GMCnet] Transcontinental record...

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Oct 07 03:17:04 CDT 2024

Total time taken to generate the page: 0.00681 seconds