Drive axle nut torque [message #227665] |
Tue, 29 October 2013 21:48 |
midlf
Messages: 2212 Registered: July 2007 Location: SE Wisc. (Palmyra)
Karma:
|
Senior Member |
|
|
I was tightening the drive axle nut to spec torque and it just didn't "seem tight enough". So I took a look in the various maintenance manuals.
'73 MM calls for 110
'75-'76 calls for 140-280
'76 supplement calls for 110-140
All are listed as plus enough additional tightening to insert the cotter pin.
So after all the years since the above info was published is there a consensus as to the proper torque value to use?
Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI
|
|
|